Revision [4996]

Last edited on 2017-09-10 12:15:02 by Vojtech Blahout
Additions:
~1) Flip the holder and screw in the two screws. --- ---Make sure again that the screws will not enter the wood farther than **8-9 mm** to avoid penetrating into the wood that will remain in the finished plate. --- ---The holder must hold the plate firmly but avoid over-tightening.
~1) Remove the temporary clamps and clamp down the holder to the workbench.
~1) Using a suitable gougle, pare away the wood down to the **6 mm** height-line, you previously created. Make sure you do not "enter" the waist **"v"** of the plate more than **15 mm.** --- ---Take a look at the red arrows in **Fig. 3** to see the general direction of carving. --- ---As you continue removing wood be extremely careful in the area of corners, as these are easily split off. Be extra sensitive of the grain in those areas and apply only very limited force. See the red arrows near the corners in **Fig. 3** for the direction of carving. Also make sure your gouge is razor sharp.
Deletions:
~1) Flip the holder and screw in the two screws. --- ---Make sure again that the screws will not enter the wood farther than **8-9 mm** to avoid penetrating into the wood that will be in the finished plate. --- ---The holder must hold the plate firmly but avoid over-tightening.
~1) Remove the clamps and clamp down the holder to the workbench.
~1) Using a suitable gougle, pare away the wood down to the **6 mm** height-line, you previously created. Make sure you do not "enter" the waist **"v"** of the plate more than **15 mm.** --- ---Take a look at the red arrows in **Fig. 3** to see the general direction of carving. --- ---As you continue removing wood be extremely careful in the area of corners, as these are easily split off. Be extra sensitive of the grain in those areas and apply only very limited force. See the red arrows near the corner in **Fig. 3** for the direction of carving. Also make sure your gouge is razor sharp.


Revision [4758]

The oldest known version of this page was created on 2015-11-05 14:02:24 by Vojtech Blahout