Revision [5005]

Last edited on 2017-09-10 12:44:02 by Vojtech Blahout
Additions:
~1) On the top plate, remove material all over the surface up to the red line, down to **4 mm**, which means that the holes from the graduation punch will start disappearing. On the back plate, remove the material down to **6 mm**.
Deletions:
~1) Remove material all over the surface up to the red line, down to **4 mm**, which means that the holes from the graduation punch will start disappearing.


Revision [4799]

The oldest known version of this page was created on 2016-02-01 13:43:29 by Vojtech Blahout