Revision [4991]

Last edited on 2017-07-30 18:51:53 by Vojtech Blahout
Additions:
The same applies for M2 and M1 modes. The M2 should be somewhere about half of M5 and M1 could be above half of M2. For best results make sure the speaker is at the sweet spot and so are the foam pads. The nodes should really have almost no vibrations at all while the rest should be vibrating strongly.
Deletions:
The same applies for M2 and M1 modes. The M2 should be somewhere about half of M5 and M1 could be above half of M2. For best results make sure the speaker is at the sweet spot and so are the foam pads. The anti-nodes should really have almost no vibrations at all while the rest should be vibrating strongly.


Revision [4990]

Edited on 2017-07-30 18:50:54 by Vojtech Blahout
Additions:
See **Fig. 1-3** for M1, M2 and M5 modes Chladni patterns. The red circle is where the driver {speaker} should be placed. The red rectangles denote the positions of foam patches which support the plate at the nodes.
Deletions:
See **Fig. 1-3** for M1, M2 and M5 modes Chladni patterns. The red circle is where the driver {speaker} should be placed. The red rectangles denote the positions of foam patches which support the plate at the anti-nodes.


Revision [4862]

The oldest known version of this page was created on 2016-02-15 13:56:10 by Vojtech Blahout